FloTest
– High accuracy
– Very low resistance
– Flow measurement under high pressure
– Robust
Specifications & Manuals
FloTest User Manual
Manual
FloTest Datasheet
Datasheets
FAQs and Articles
How do I Calibrate the Zero offset on my FloTest/F2?
Before the Measurement
- Remove the protection caps from both sides of the flow measurment channel
- Allow the FloTest/F2 to warm-up for about 15 minutes
- Press the Menu tab, located on the top left hand side of yout screen
- Select the "Zero Calibration" option
- Press the "Start calibration" tab to begin the calibration
- Once completed, you will receive a prompt for a succesful calibration
Please note the following:
- For a short moment after the zero calibration, allow the instrument to settle, and the zero value will be displayed
- Ensure that the 10 to 15 minutes warm up time is allowed, or your calibration may be unsuccessful. This should be performed in the environment that you intend to perform your testing.
- During a zero calibration it is important that no pressure or flow is applied to any connector and that the protection caps are removed
The Accuracy will remain valid within the following conditions:
- Between 10°C and 30°C (channel temperature)
- Between 950 hPa and 1250 hPa (hectoPascals)
- The zero offset calibration performed after the required warm-up period
- For measurements performed within 4 h after last zero offset calibration at same ambient conditions
.
How do I Calibrate the Zero offset on my FloTest/F2?
Before the Measurement
- Remove the protection caps from both sides of the flow measurment channel
- Allow the FloTest/F2 to warm-up for about 15 minutes
- Press the Menu tab, located on the top left hand side of yout screen
- Select the "Zero Calibration" option
- Press the "Start calibration" tab to begin the calibration
- Once completed, you will receive a prompt for a succesful calibration
Please note the following:
- For a short moment after the zero calibration, allow the instrument to settle, and the zero value will be displayed
- Ensure that the 10 to 15 minutes warm up time is allowed, or your calibration may be unsuccessful. This should be performed in the environment that you intend to perform your testing.
- During a zero calibration it is important that no pressure or flow is applied to any connector and that the protection caps are removed
The Accuracy will remain valid within the following conditions:
- Between 10°C and 30°C (channel temperature)
- Between 950 hPa and 1250 hPa (hectoPascals)
- The zero offset calibration performed after the required warm-up period
- For measurements performed within 4 h after last zero offset calibration at same ambient conditions
.
Standards & Compliance
Register Your Product
Register your product today to activate your warranty and to stay up to date with the latest product updates, news and support information.
Or tell us what you’re looking for
Calibrate your FloTest
If you wish to calibrate your FloTest, please locate the nearest service center or contact us directly using the link below.
Stay in the know
Sign up to our mailing list today to stay up to date with the latest industry news and information from Seaward.
Part of the GMC Group
Part of GMC Instruments
Contact us
Email: sales@rigelmedical.com
Switchboard: +44 (0) 191 586 3511
Phone: +44 (0) 191 587 8730
